Question: How Much Will My Electric Bill Go Up With A Pool?

Does a swimming pool pump use a lot of electricity?

Hi Joe, outside of the air conditioner, the pool pump is the largest energy consumer in the average pool-containing home.

Pool pumps use up to 2,500 kWh per year to circulate and filter the water.

The average monthly costs for a 1 HP pump running 8 hours per day in Florida is approximately $30*..

Is a swimming pool worth it?

Not only does a pool increase your social worth, but it can also increase the value of your home. But probably not as much as you think. According to HouseLogic, there’s no real guarantee that you’ll make your money back. In fact, adding a swimming pool may only increase your home’s value by 7%.

Is it harder to sell a house with a pool?

It won’t be easy since a swimming pool can actually make your home harder to sell. Many buyers consider it a liability rather than a luxury. Under the right circumstances, however, a pool could boost your home’s value by as much as 7%, Houselogic estimates.

Can I leave my pool pump off for a week?

First things first, your pool needs ample filter run time in order to keep up. At E-Z Test Pools we always recommend running the pump and filter 12 hours per day, every day. … If you know that you will be away for more than a week, it is best to have someone shock the pool once a week as well.

How often should a pool be cleaned?

Some filters may require monthly cleaning, some require cleaning every two months, others every three to four. You will also want to check your water level at least once a month. Over the course of a hot summer pool water will evaporate and the water level in your pool will go down.

How many hours a day should a pool pump run?

eight hoursThe rule of thumb for pool maintenance is to run your pump for eight hours per day.

What type of pool lasts the longest?

Concrete poolsConcrete pools have the longest service life, assuming it is well built, followed by fiberglass and then vinyl liner pools as a tie, more or less, for second place. A concrete pool can still be in serviceable condition, and daily use, after as much as 50 or 75 years.

Should a pool pump run all the time?

There is no need to run a pool pump continuously for 24 hours a day, with a few exceptions. It is normally recommended that your pool pump should run long enough to pump the entire volume of water in a pool each day. In practice, this generally means around 8 hour each day.

How much does it cost per month to have a pool?

The average cost to maintain a pool is $80 to $150 monthly or about $960 to $1,800 yearly. For a first-time pool cleaning service, expect to spend $150 to $350 on average. The annual cost to own a pool is $3,000 to $5,000, which includes maintenance, repairs, electricity, and water.

What is the cheapest inground pool?

Basic vinyl liner pools are the least expensive inground swimming pool option. Vinyl liner swimming pools give you more swim area for the money and cost you less initially than a fiberglass pool or gunite pool.

How often should a pool filter be cleaned?

every 3 monthsA commonly asked question amongst our customers is, “when should we clean our pool’s filter cartridge?” Typically, we recommend that your cartridges inside your filter be cleaned every 3 months for longevity of your cartridges, as well as for better pool filtration and water flow.

What causes a high electric bill?

One of the main reasons your electric bill may be high is that you leave your appliances or electronics plugged in whether you’re using them or not. … Anything with a clock, such as microwave ovens and coffee makers — and even older technologies, like VCRs — need the power to keep time while turned off.

How much power does a 1.5 HP pool pump use?

It’s not uncommon for a 1.5 horsepower pump to use 1500 – 2000 watts. This is unfortunate, because most pools only need 1/4 to 1/8th horsepower for circulation. Higher power may be needed for tasks like vacuuming the pool.

How much does having a pool increase your electric bill?

According to the study, at the national average of 11.8 cents per KWh, a pool pump alone can add as much as $300 a year to an electric bill. However, Opower’s investigation revealed that its not just the actual pool that accounts for the massive increase in energy consumption of homes with swimming pools.

Is it expensive to maintain a pool?

Annual Cost to Upkeep a Pool. Expect to spend between $1,200 and $1,800 per year in basic upkeep. Combined with swimming pool repairs and utilities, homeowners can spend as much as $3,000 to $5,000 per year to keep it in good, working condition.

Is it OK to run pool pump 24 hours a day?

To conclude, running your pool pump for 24 hours is not a bad thing. It is actually ideal to do so. But since it can significantly increase pool maintenance cost, we suggest only running your pump for 12 hours or less, depending on the size of your pool and the efficiency of your pump.

Is it bad to run your pool pump 24 hours a day?

Ideally, you should run your pump for 24 hours a day, but we know that’s unrealistic (and pricey), so let’s look for an answer that keeps your pool clean and your wallet full. Generally running your pool pump for 12-hours a day is a good option. … For a residential pool the water should turn over at least once per day.

Is it better to run a pool pump at night or day?

Running your pool pump during the day is good because that’s when the sun is out. UV rays are eating up the chlorine, so it is good to have the pump running to counteract the sun’s effects. … It’s cheaper to run the pool pump at night.

How far does a pool have to be from a house?

1000mmA good rule of thumb is to position the pool at least 1000mm from the boundary. Homeowners usually choose to landscape within this boundary area to enhance the overall space. For pools in confined spaces, there is a much greater need to echo the overall style of the adjoining home.

When should you backwash your pool?

As a general rule, you should be backwashing your pool about once a week or in conjugation with your scheduled maintenance. Another industry standard is to backwash when your filter’s pressure gauge reads 8-10 PSI (pounds per square inch) over the starting level or “clean” pressure.